5
M10 Split
Washer (80)–2
M10 x 20mm x 2mm
Washer (95)–4
M10 x 16mm
Washer (123)–4
M10 Washer
(93)–2
M10 Locknut
(96)–2
M5 x 12mm
Screw (71)–29
M5 x 10mm
Truss Screw
(73)–2
Wave Washer
(36)–2
M10 x 20mm
Screw (111)–4
M10 x 15mm Hex
Screw (94)–2
M10 x 75mm Bolt (108)–2
PART IDENTIFICATION CHART
Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the
key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it
has been preassembled. Extra parts may be included.
To Next Page
Loading...
