Any concerns? support@freenove.com
Programs written with Arduino Software (IDE) are called sketches. These sketches are written in the text
editor and saved with the file extension.ino. The editor has features for cutting/pasting and
searching/replacing text. The message area gives feedback while saving and exporting and also displays
errors. The console displays text output by the Arduino Software (IDE), including complete error messages
and other information. The bottom right-hand corner of the window displays the configured board and
serial port. The toolbar buttons allow you to verify and upload programs, create, open, and save sketches,
and open the serial monitor.
Verify
Check your code for compile errors .
Upload
Compile your code and upload them to the configured board.
Debug
Debug code running on the board. (Some development boards do not
support this function)
Development board selection
Configure the support package and upload port of the development
board.
Serial Plotter
Receive serial port data and plot it in a discounted graph.
Serial Monitor
Open the serial monitor.
Additional commands are found within the five menus: File, Edit, Sketch, Tools, Help. The menus are context
sensitive, which means only those items relevant to the work currently being carried out are available.
To Next Page
Loading...
Need help?
General