To Next PageTo Next PageTo Previous PageTo Previous Page
Need help?Do you have a question about the Freenove ESP32-S3 and is the answer not in the manual?
General| Brand | Freenove |
|---|---|
| Model | ESP32-S3 |
| Category | Control Unit |
| Language | English |
Instructions for initial setup and reading the 'Start Here.pdf' document.
Information on obtaining technical support and providing feedback to Freenove.
Essential safety guidelines and warnings for using the product.
Introduction to the ESP32-S3 microcontroller unit and its features.
Guide to installing the CH343 driver for Windows and macOS.
Instructions for installing and setting up the Arduino IDE for programming.
Steps to configure the Arduino IDE for ESP32-S3 board support.
Details on strapping pins and their configurations for ESP32-S3.
A project demonstrating how to control an LED to blink using ESP32-S3.
Sending data from ESP32-S3 to a computer via serial communication.
Receiving data from a computer and sending it to ESP32-S3 via serial.
Demonstrates data transmission using Bluetooth Low Energy between ESP32-S3 and mobile phones.
Using ESP32-S3 to read and write data to an SD card via SDMMC interface.
Guide for formatting an SD card on Windows and macOS systems.
Configuring ESP32-S3 to connect to a WiFi router as a client.
Setting up ESP32-S3 to act as a WiFi Access Point (hotspot).
Enabling ESP32-S3 to operate as both a WiFi client and Access Point simultaneously.
Using ESP32-S3 as a TCP client to connect to a server on the same LAN.
Using ESP32-S3 as a TCP server to accept client connections.
Accessing ESP32-S3 camera stream via a web browser.
Viewing real-time video data from ESP32-S3 camera via web pages.
Capturing photos with ESP32-S3 camera and saving them to an SD card.
Displaying ESP32-S3 camera video data on a mobile phone.
Concluding remarks and contact information for further assistance.