2201 Cantu Court Suite 215 Sarasota, FL 34232 Page 6 of 23
(941) 378-4242 (800-237-3928 Fax (941) 378-2765
Stewartsigns.com
Figure #7 “Serial Setup 2” Window (Building Unit)
4. Configuring the “Radio Setup”. See figure #8.
a. Click on “Radio Setup”.
b. Set the “Network Type” to “Point-to-Point”.
c. Set the Modem Mode to “Gateway”.
d. Click on “Save/Apply” to save your settings.
e. Click on “Call Book” (near the bottom of the “Radio Setup” Window. This will
open the Call Book Window. See figure #9.
f. Call Book Window enter the serial number of the OTHER Transceiver in the
space provided in line 0. See figure #9. (The Serial Number of the Transceiver
can be found on the label attached to the Transceiver).
g. Click on “Save/Apply” to save your settings.
h. Click on “Radio Setup” to get back to the “Radio Setup Browser Window”
i. Click on “Save/Apply” and then “Reboot” button for the ALL the changes to
take effect.
j. Close all Browser Windows. This concludes the programming of the Transceiver
for your building.
To Next Page
Loading...
