freightliner EconicSD - Page 183

Electrical fuses
Important safety notes
G
WARNING
If you manipulateorbridge afaultyfuse or if
you replace it with afuse with ahigher
amperage, theelectric cables couldbeover-
loaded.This couldresult in afire. Thereisa
risk of an accidentand injury.
Always replace faultyfuseswith thespeci-
fied new fuseshavingthe correctamperage.
The fuse box is locatedinthe electrical equip-
mentcompartmentbehindthe driver'sseat.
The individual electrical circuitsare protected
by safety fusesorautomatic circuit-breakers.
Blown fusesordefective automatic circuit-
breakers must be replaced with equivalent
fuseswith thefuse ratingsrecommended in
thefuse allocationchart.Fuses with thesame
fuse rating are thesame color.
You can obtain further informationfromany
Freightlinerservicecenter.
The fuse allocationchart is on theinside of the
main fuse carrier cover.
If thenew fuse whichhas been inserted also
blows,have thecausetraced and rectified at a
qualified specialist workshop.
X
If acircuit fails,switch off theconsumer
equipment and turnthe keyback in theigni-
tionlockasfar as it will go.
Removing theelectrical equipment
compartment cover
X
Loosen screws :.
X
Pull electrical equipment compartment
cover ; up and out.
Layout of thefuses
Fuses in FA1modules
Consumer
F1 Drive control (CPC)
terminal 30
20 A
F2 Programmable spe-
cial module (PSM)
terminal 15
15 A
Driver assistance
system (VRDU),
LaneKeeping Assist
camera (MPC)
terminal 15
15 A
Distance sensor
control unit (RDF)
terminal 15
15 A
F3 Steering wheel
angle sensor (SAS)
terminal 30
5A
F4 Driver assistance
system (VRDU),
LaneKeeping Assist
camera (MPC)
terminal 30
10 A
Distance sensor
control unit (RDF)
terminal 30
10 A
F5 Central gateway
(CGW) terminal 30
10 A
F6 12 Vbasic wiring
for radio/tele-
phone/fax
terminal 15R
10 A
F7 24 Vradio
terminal 30
15 A
Programmable spe-
cial module (PSM)
terminal 30
15 A
Electrical fuses
181
Breakdown assistance
Z