3. Remove the filter, filter cover, and gasket from
the reservoir.
4. Disconnect the filter from the filter cover, and
discard the filter.
5. Apply a thin film of power steering fluid on the
gasket of the new filter. Then attach the filter to
the filter cover.
6. Check for damage to the gasket that was
removed from the reservoir. If the gasket is
damaged, replace it. Install the gasket on the
reservoir.
7. Install the filter and filter cover in the reservoir.
8. Check the fluid level in the reservoir. If
necessary, add fluid to the reservoir to maintain
the fluid level between the MIN COLD and MAX
HOT lines. See
Table 1 for approved power
steering fluids.
9. Raise the vehicle and remove the jack stands,
then lower the vehicle.
10. Remove the chocks from the tires.
Steering 46
Business Class M2 Plus Maintenance Manual, 02/10/2023 46/3
To Next Page
Loading...
