LUBRICATION
Lubricate the Counterbalance Spring, Counterbalance Shaft Bearings, Rollers, Hinges, Top Fixtures,
Bottom Roller Holders and Locks liberally with Transglobal Lube. Do NOT use grease. Wipe dirt from
track. Frequency of door maintenance will vary with climate conditions and door cleaning procedures.
Doors which are steam cleaned will need lubricated more often. Doors on equipment operated in areas
where road salts are used will require lock lubrication at closer intervals. Do NOT use any petroleum-
based lubricant on rubber door seals.
TGS1000
ADVANTAGES
Long lasting, non-toxic, non-static, non-staining, non-conductive,
contains no petroleum distillates, no silicones, no acids,
no carcinogens, no halogens and no allergens. Will not dry out, or
wash off with water. Will not damage plastics, paints, metals,
fiberglass, enamels, or neoprene seals. No petroleum smell.
H- Registered for Food Processing Areas.
USES
Lubricate and protect locks, hinges, rollers, air tools, roll-up doors,
lift gates, springs, chains, and bearings. Cutting oil for drilling and
tapping. Penetrates and neutralizes rust on nuts, bolts, screws,
equipment and motors. Cleans corrosion and oxidation off battery terminals and metals.
(See for Lubrication points below.)
To Next Page
Loading...