freightliner MT45 2019 - Code Enrollment; Key Fob Enrollment Procedure

To Next Page

To Previous Page

Genuine OEM Parts 1.800.233.4823 www.morganolsonparts.com

Quick Code Enrollment

1. Car MUST be stopped AND engine OFF

2. Press the fob button once

Engine Start / Stop switch back light begins ashing, indicating a Valid ID has been detected

3. Press and HOLD the Engine Stop switch for 5-seconds

Engine Start / Stop switch back light will turn ON solid

4. After 5-seconds has elapsed

Engine Start / Stop switch back light will icker-ash indicating receiver is in “Learn” mode

5. RELEASE the Engine Stop switch

6. Press the button on NEW fob that is being enrolled

7. If code enrollment is successful

Engine Start / Stop switch back light will double ash and receiver will exit “Learn” mode

8. Test the new fob to verify it has been enrolled correctly

NOTE: Only ONE fob can be enrolled using the Manual ALL Erase & Code enrollment method

CODE ENROLLMENT