FREMCO A/S
ELLEHAMMERVEJ 14 | DK9900 FREDERIKSHAVN, DENMARK | VAT NO.: DK30815416
TELEPHONE +45 7230 1213 | SALES@FREMCO.DK | WWW.FREMCO.DK
10. FIBER PROTECTION
The NanoFlow MAX safety system is unique as it protects the fiber from damage, regardless of the machine
setting. The protection system comprises two functions:
Torque Limitation
The system adjusts the pushing force on the fiber.
It means that you can control the load on the fiber
during the blowing process. As a main rule: the
larger the fiber, the higher load it can withstand.
At a point in a typical blowing process, the fiber
blowing speed will decrease due to friction in the
duct. The higher setting of torque, the later this
will happen.
At a point the blowing will stop, as it is no longer
possible to push the fiber with the chosen torque
setting.
The display on the machine
shows “FIB OFF” (fiber
stop).
Wheel Spin Supervision
The system continuously monitors if drive wheel
and support wheel run with the same speed. If
there is a difference in speed, it means that the
drive wheel is spinning on the fiber, and the system
immediately stops the blowing process.
The display on the machine shows “FIB OFF” (fiber
stop).
Typically, this situation will
occur if torque is set too
high for the fiber in question.
Automatic Stop Function
The protection system can be used to make the machine stop automatically when it has reached the goal. All
you need to do is to mount a fiber stop at the end of the duct.
To Next Page
Loading...