Fresenius Medical Care GranuFlo 450368-03 User Manual

10 P/N 450368-03 Rev. E
SECTION 5: GRANUFLO DISSOLUTION UNIT II PREPARATION
1. Power Cord is connected to 115 Volt, 60 Cycle, Single Phase, 15 Amp, GFI protected circuit.
2. Be certain the Drain Hose is over a floor drain.
3. Transfer Hose is connected to the Transfer Hose Holder of the GranuFlo Dissolution Unit II.
4. Make sure input water source is turned ON.
5. Power Switch is in the ON position.
NOTE:
INPUT WATER PRESSURE DIRECTLY AFFECTS HOW FAST THE GRANUFLO DISSOLUTION UNIT II WILL FILL
.
THE
MAXIMUM INPUT WATER PRESSURE IS 60 PSI.

Fresenius Medical Care GranuFlo 450368-03 Specifications

General

Brand	Fresenius Medical Care
Model	GranuFlo 450368-03
Category	Medical Equipment
Language	English