EasyManua.ls Logo

FRESKO CM001 - Page 7

FRESKO CM001
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FROTHING MILK/ MAKE CAPPUCCINO
Method:
You get a cup of cappuccino when you top up a cup of espresso with frothing milk.
Note: Before frothing milk, release steam for 10 seconds, during making steam, the
metal funnel must be assembled in position.
Press the steam button “ ”, the steam indicator will flashing. When steam
indicator becomes solid, the pre-heating is finished.
Prepare espresso first with container big enough according to the part “MAKE
ESPRESSO COFFEE”.
Fill a jug with about 100 grams of milk for each cappuccino to be prepared, you
are recommended to use whole milk at refrigerator temperature (not hot!).
Note: In choosing the size of jug, it is recommended the diameter is not less than
70±5mm, and bear in mind that the milk increases in volume by 2 times, make
sure the height of jug is enough.
Insert the steam wand into the milk about two centimetre, then turn the knob to
the “ ” position, steam will come out from the steam outlet. Froth milk in the
way moving vessel round from up to down.
Warning: Be sure to operate carefully as the steam may result in scald to person.
When the required purpose is reached, you can turn the knob off.
Note: Clean steam outlet with wet sponge immediately after steam stops
generating, but care not to hurt!
Pour the frothed milk into the espresso prepared, now the cappuccino is ready.
Sweeten to taste and if desired, sprinkle the froth with a little cocoa powder.
The steam wand can be used to froth milk singly or make hot beverages like
drinking chocolate and water.
Note: After making steam, you can press “Single-cup” or “Double-cup” button
immediately to brew coffee again. The coffee indicator will flasing quickly if the
temperature is too high, at this time, you need to reduce the temperature by
following the operation as below. Turn the knob to “Hot water” setting “ ”, and
then the hot water will dispense. When the temperature goes down ,the pump
will stop automatically and you should turn the knob off , then you can brew
coffee again.
Note: If you do not want to brew coffee when the high-temperature warning
occurs, you can press the “Single-cup” or “Double-cup” button again to cancel.
05
MAKE HOT WATER
After finish preheating, turn the knob to “ ” position, and then the hot water will
dispense from steam wand. When desired amount of hot water is got, turn the
knob off. Before making hot water, put a cup under the steam wand.