EasyManua.ls Logo

FRESKO CM001 - Clean and Maintenance

FRESKO CM001
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
06
AUTOMATICALLY POWER-OFF FUNCTION
After pressing power button, if there is no any operation within 29 minutes, the
unit will power off automatically.
After pressing power button, if there is no any operation after pump puming
about 215ml water , the pump will stop automatically.
After pressing power button, if there is no any operation after pump worked
for 180s during froth milk, the pump will stop automatically.
CLEAN AND MAINTENANCE
Cut off power source and let the coffee maker cool down completely before
cleaning.
Clean housing of coffee maker with moisture-proof sponge often and clean
water tank, drip tray and drip plate regularly then dry them.
Note: Do not clean with alcohol or solvent cleanser. Never immerse the housing
in water for cleaning.
SET THE DISPENING AMOUNT
Dispensing amount of single cup
Hold and press the “Single-cup” button for 3 seconds to enter into the mode of
setting the dispensing amount. And then press the “Single-cup” button again, the
coffee starts to dispense and the “Single-cup indicator” flashes at the same time,
when the desired amount is got, press the “Single-cup” button again, the coffee
stops dispensing. At that time, the setting for the dispensing amount of single cup
is finished and it will be saved for next operation.The adjustable dispensing
amount of single cup ranges between 25ml and 60ml.
Dispensing amount of double-cup
Hold and press the “Double-cup” button for 3 seconds to enter into the mode of
setting the dispensing amount, then follow the operation of setting the dispensing
amount of single cup. The adjustable dispensing amount of double-cup ranges
between 70ml and 110ml.
Restore factory setting
Simultaneously hold and press the “Single-cup” and “Double-cup” buttons for 3
seconds to recover the factory setting of dispensing amount.
Detach the metal funnel by turning it clockwise, get rid of coffee residue inside,
then you can clean it with cleanser, but at last you must rinse with clear water.
Clean all the attachments in the water and dry thoroughly.