Fridgemaster MUZ4860MF

Questions and Answers

W
Wayne RuizAug 10, 2025
What to do if my Fridgemaster MUZ4860MF Freezer does not work?
- D
  Dennis SmithAug 10, 2025
  If your Fridgemaster Freezer isn't working, there are several potential causes: * The appliance might not be switched on, so ensure it is. * The mains plug might not be properly inserted or could be loose; check and insert it fully. * The fuse might have blown or be defective; inspect the fuse and replace it if needed. * The socket itself could be defective; in this case, an electrician should correct the mains malfunctions.
C
Cheryl SuttonAug 16, 2025
Why is my Fridgemaster MUZ4860MF food too warm?
- D
  David LaraAug 16, 2025
  If the food in your Fridgemaster Freezer is too warm, it could be due to several reasons: * The temperature might not be properly adjusted. * The door may have been open for too long; ensure you only open it when necessary. * A large amount of warm food might have been placed inside recently; temporarily turn the temperature regulation to a colder setting. * The freezer could be near a heat source.
A
Austin SolisAug 23, 2025
Why is my Fridgemaster Freezer cooling too much?
- N
  Nicole CannonAug 23, 2025
  If your Fridgemaster Freezer is cooling too much, it's likely that the temperature is set too cold. Try adjusting the temperature regulator to a warmer setting temporarily.
N
nguyenthomasAug 29, 2025
Why won't the compressor start immediately on my Fridgemaster MUZ4860MF?
- D
  Dawn TaylorAug 29, 2025
  If the compressor in your Fridgemaster Freezer doesn't start immediately after changing the temperature setting, don't worry. This is normal, and no error has occurred. The compressor will start after a period of time.
P
Paul KempSep 3, 2025
Why is my Fridgemaster MUZ4860MF making unusual noises?
- E
  Eduardo AdkinsSep 3, 2025
  Unusual noises from your Fridgemaster Freezer can be caused by a few things: * The appliance might not be level; try readjusting the feet. * It could be touching the wall or other objects; move it slightly. * A component on the rear, like a pipe, might be touching another part or the wall; carefully bend it out of the way if needed.