16 PB
OPERATION
User Interface
All of the control panel function buttons and mode icons can be viewed in Figures 302 and 303.
Power On – Press the button to turn on the air conditioner. The power button illuminates to indicate that the power is on. The
backlight on the power switch will automatically turn off after 20 seconds of inactivity. The remote control can also be used to
turn power ON / OFF (see Remote Control).
Display – The display is a high efciency LCD with a built-in backlight. After 20 seconds of inactivity, the display switches off.
Touching any button automatically changes the display to full brightness.
There are three control push buttons on each side of the display.
MODE
Cycles between AUTO,
HEAT, COOL, or FAN
ONLY
CONTROL PANEL
TEMPERATURE
INCREMENT UP
AND DOWN
ON / OFF
Turns unit on / off
IR WINDOW
Do not block
FAN
Sets fan to either:
-automatically cycle
-continuosuly run
SPEED
Sets fan speed
LOW, MED, HIGH, OR MAX
(Actual settings are model
dependent)
DISPLAY
Figure 303
Figure 302
Unit
Mode
Display
Disconnected From
Power Board
Control
Locked
Wi-Fi Operating
State
2 Digit Display
Shows Settings for:
-Set Point
(Temperature)
-Clock (AM/PM)
Filter
Check /
Clean
Timer/
Schedule
Shows
On / Off
To Next Page
Loading...
Need help?
General
