Friendly Robotics robomower RL350 - Page 69

3
3.2.2 Power & Charging Problems (con.)
14
+
-
There is no
Charging indication
although the
Power Supply is
connected
In any case of char
g
in
g
problem or failure, it is
recommended first to
perform the charging
test as explained in
section 5.4.9 (page
5.13).
3.2.2.4
 Confirm the Power Supply is plugged
into the Mains Supply
 Ensure the Mains Supply is turned on
 Test that the main socket is working
by plugging another appliance
 Confirm the Power Supply connector
is fully inserted into the charging
socket
 Confirm that the charger plug is not
corroded / rusty
 Unplu
g
and plu
g
the char
g
er from the
Robomower
 Confirm that there is no corrosion
inside the charging socket
 Reset the Robomower by removing
the Power Pack and re-insertin
g
i
t
Y
ES
NO
Is the AC volta
g
e
from wall at
least 110 (US)/
220(EUR) volts?
Is the DC
output from
Power Supply
at least 32
volts?
 Replace connector board (ESBC0021C)
 Replace flat cable (WSB0052A)
 Replace Main Board (SPP0019C)
Replace power Supply
(US – PWS0003A)
(UK – PWS0002A)
(EUR – PWS0001A)
Replace Manual Controller Holder
Assembly (MSB0105B)
Use another
outlet
NO
Y
ES