Frigidaire FAS156N1A2 User Manual

Installation Instructions
For Heavy Duty
Please read ALL instructions before installing. Two people are
recommended to install this product. Ifa new electrical outlet
is required, have the outlet installed by a qualified electrician
before installing unit. See#5 in Preliminary Instructions
following.
Preliminary Instructions
Do the following before starting to install unit. See illustrations
below.
1. Check window opening size - the mounting parts furnished
with this air conditioner are made to install in a wooden
sill double-hung window. The standard parts are for a
window opening of 31 "(711 mm) minimum to 42"( 1067
rc_n) maximum width. Open sash to a minimum of 19"
(483 mm). (FIG. 1)
2. Check condition of window - all wood parts of window
must be in good shape and able to firmly hold the needed
screws. If not, make repairs before installing unit.
WINDOW SASH SEAL
3/4" LONG HE)( HEAD
SCREW
WASHERHEAD
FRAME
ASSEMBLY
(LEII)
SDE RETAINER
SEAL-BOI tOM RAIL TC UNIT
I/2'LOFIG
SCREWS AND "_i FRAME
O_'KN JTS _ ASSEMBLY
\._ _#W-! (lEFT)
OCKNJ [ _ WINDOW _!IPPORT
3/4 'LONG
D_____ " BRACKET
BOLT SI ANGI
BRACKET
3. Check your storm windows - if your storm window
frame does not allow the clearance required, correct by
adding a piece of wood as shown in FIG. 2, or by removing
storm window while room air conditioner is being installed.
(continued)
FIG. 1
_ SASH
T
19" MIN.
STORM WINDOW FRAME OR
OTHER OBSTRUCTION
FIG. 2 [_SASH
1
19" MIN_
112"MIN 1 1/2"MIN.
ENTIRE STOOL. FASTEN
STORM WINDOW FRAME OR WITH TWO NAILS OR
OTHER OBSTRUCTION SCREWS.
309000906(11/03)

Frigidaire FAS156N1A2 Specifications

General

Brand	Frigidaire
Model Number	FAS156N1A2
Type	Window Air Conditioner
Voltage	115V
Amperage	12.5 A
Number of Cooling Speeds	3
Number of Fan Speeds	3
Installation Type	Window
Cooling Capacity (BTU)	15000 BTU
Room Size Coverage (sq ft)	700 sq ft
Filter Type	Washable

Summary

Preliminary Instructions

Check Electrical Service

Verify the power supply matches unit requirements and an outlet is nearby.

Window Mounting

Place Cabinet in Window

Position the cabinet in the window opening, aligning it and securing it to the stool.

Install Support Bracket

Attach support brackets to the sill and cabinet, ensuring proper alignment and tightness.

Thru-The-Wall Installation

Prepare Wall

Cut or knock out holes in the center stud and measure between studs for the opening.

Measure and Cut Opening

Determine opening width (X) and height (Y) based on framing material thickness.

Prepare and Install Cabinet

Install Chassis into Cabinet

Install the chassis into the cabinet following specific steps for window mounting.