14
Timer Functions
This appliance is equipped with three timer options: minute countdown timer, cook time (dur), and end
time (END).
Table 2: Timer Functions
Function Application
Minute Timer ( )
Use to track your cooking times without interfering with the cooking process.
The timer may be set from a minimum time of 1 minute to a maximum of 23
hours and 59 minutes
Minute Timer (dur) Use to set the cooking time of the oven, from 1 minute to 10 hours.
End Time (END) Use to program the oven when to stop cooking, from 1 minute to 10 hours.
Display Indicators
Figure 12 : Clock display functions
• A: Duration and End time indicator
• B: Time display
• C: Timer active indicator
• D: Minute timer indicator
To set a timer function:
1. For Duration (dur) and END (end), use the oven
temp and oven mode knobs to set an oven
function and cooking temperature. (This is not
necessary for .)
2. Press timer on-o until the desired function op-
tion appears, indicated by the bell symbol, dur,
or END, and starts to flash.
3. Press
or to set the desired timer
function. The timer function activates, and the
corresponding indicator will appear in the dis-
play. For End and dur, A will also appear in the
display.
NOTE
Duration and End time may be used at the same
time if you want the appliance to activate and de-
activate automatically. First, set Duration. Then,
set End.
4. When the time ends, the function’s indicator on
the display will start flashing and an signal will
sound for two minutes. Press any button to stop
the signal.
IMPORTANT
With the Duration and End functions, the appli-
ance will stop cooking automatically.
To cancel the timer function:
1. Press timer on-o until the desired function
option appears.
2. Press and hold
and at the same time.
The timer function will go out after several sec-
onds.
To change the acoustic signal:
1. To hear the current signal, press and hold
.
2. Repeatedly press
to change the signal.
3. Release
. The last tone you heard will be
the new signal.
4. Wait five seconds for the setting to be con-
firmed.
NOTE
When the appliance is disconnected from the
outlet or after a power outage, the signal tone
will be set back to the default tone..
SETTING OVEN CONTROLS
To Next Page
Loading...
