Operating I nstructions
Fault Codes
1. If the display reads "AS" or "ES" , a sensor has failed. Contact your Authorized Frigidaire Service Center.
2.If the display reads "EC" , check the following operating conditions. Outlet voltage should be 115V± 10% and the
surrounding temperature should be with in the range of 41 ° F to 89 °F. Unplug the unit and plug it in again under
normal operating conditions. I f the "EC" code persists, contact your Authorized Frigidaire Service Center.
Removing Collected Water
1. Emptying the Bucket:
a. When the bucket is full, the unit will shut down and the BUCKET FULL indicator will illuminate.
7
2019 Electrolux Home Products, Inc. All rights reserved.
3.If the display reads “E4” , the communication between display PCB and main control PCB is faulty. Contact your
Authorized Electrolux Service Center.
b. Do not move the unit at this time otherwise water may spill on the floor.
c. Press sides of bucket gently to unclip the bucket from the unit.
d. Remove the bucket as shown in t he photographs below and empty the bucket.
Discard water from bucket. Water is not potable and cannot be used for drinking.
WARNI NG
To Next Page
Loading...
