BEFORE SETTING SURFACE CONTROLS
Element ON Callmodels)
Your appliance is equipped with two different types of
radiant surface control indicator lights that will glow on
the backguard- the Element On indicator light and the
hot surface indicator lights.
The element ON indicator lights are located on the
control panel (Figure I) between the two radiant element
control kJ1oband will glow when a surface element is
turned ON,
OFF OFF
8
3
8
7
Figure 1
Element ON indicator light location,
Hot surface indicator light
(Model C only)
The hot surface indicator light located on the cooktop
(Figure 2) will glow when any surface cooking area heats
up and will remain on until the glass cooktop has cooled
to a MODERATE level.
Figure 2 - Model C only
Hot surface indicator light location.
NOTE
The "Hot Surface" indicator lights will glow when the
element is turned on and will continue to glow after the
control knob is turned to the "OFF" position. It will glow
until the heating surface area has cooled sufficiently.
The glass surface may still be hot and burns may
occur if the glass surface is touched before the indicator
light has turned OFE The message may remain on even
though the controls are turned OFF.
12
To Next Page
Loading...
