Performing a FRITZ!OS Update
FRITZ!WLAN Repeater DVB-C 23
3. Enter a password and click “Apply”.
Password protection is enabled.
Log off the User Interface.
When password protection is enabled, you can log off the us-
er interface at any time. To do so, click .
7.3 Performing a FRITZ!OS Update
AVM provides free FRITZ!OS updates. FRITZ!OS is the device
software (firmware) of the FRITZ!WLAN Repeater.
1. Open the FRITZ!WLAN Repeater user interface (see
page 33).
2. Click “Wizards” and start the “Update FRITZ!OS” wizard.
The wizard checks whether a new FRITZ!OS update is
available for your FRITZ!WLAN Repeater.
3. To transfer a new FRITZ!OS to the FRITZ!WLAN Repeater,
click “Start Update”.
The FRITZ!OS update begins and the “Power” LED on the
FRITZ!WLAN Repeater starts flashing.
The Power update is complete when the “FRITZ!OS” LED stops
flashing.
Interrupting the FRITZ!OS update can damage the
FRITZ!WLAN Repeater. Do not interrupt the power supply
to the FRITZ!WLAN Repeater during the update!
To Next Page
Loading...
