Connecting Wirelessly Using the Configuration Wizard
FRITZ!WLAN Repeater DVB-C 17
4.2 Connecting Wirelessly Using the Configuration Wizard
If you cannot use WPS, establish the wireless connection us-
ing the configuration wizard.
The configuration wizard is started in the web browser.
Requirements
• The “WLAN Bridge” operating mode must be set in the
FRITZ!WLAN Repeater (preconfigured upon delivery of
the FRITZ!WLAN Repeater).
• DCHP must be enabled on the computer; see Obtaining
an IP Address Automatically on page 41.
• The SSID (radio network name) of the wireless access
point must be set to “visible” (announced).
• If the MAC address filter of the wireless access point is
enabled, the MAC address of the FRITZ!WLAN Repeater
must be entered as an exception.
Establishing a Wireless Connection
1. Connect the FRITZ!WLAN Repeater to an electrical outlet
in the vicinity of the FRITZ!Box.
2. Connect the FRITZ!WLAN Repeater to a computer using
the network cable included with delivery.
3. Start a web browser on the computer.
4. Enter the address http://fritz.repeater
.
The configuration wizard starts.
In the presettings of the latest FRITZ!Box models the SSID is
visible and the MAC address filter is disabled.
To Next Page
Loading...
