No Connection with the Wireless Access Point
FRITZ!WLAN Repeater DVB-C 37
WPS is disabled on the wireless access point.
Install the latest firmware for your wireless access point and
then enable the WPS function in the access point.
The encryption of your wireless access point is set to “WEP”
or “non-encrypted”. WPS can only be used with WPA/WPA2
encryption.
Configure encryption with WPA/WPA2 in the user interface of
your wireless access point.
The radio network name (SSID) at your wireless access point
is set to “not visible”.
Set the SSID to “visible”.
The SSID must be visible to establish a connection using
WPS. Once the connection has been established you can re-
set the SSID of the wireless access point back to “not visi-
ble”.
The MAC address filter of the wireless access point is enabled
and the FRITZ!WLAN Repeater is not entered as an exception
in the MAC address list of the wireless access point.
Enter the MAC address of the FRITZ!WLAN Repeater as an ex-
ception in the MAC address filter of the wireless access point.
Cause
Help
Cause
Help
Cause
Help
Cause
Help
To Next Page
Loading...
