Button and LEDs
FRITZ!WLAN Repeater DVB-C 9
LEDs
LED Condition Meaning
Signal
strength
flashing
• Searching for wireless access point
• No connection with the wireless access
point
on The more LEDs are lit up, the stronger the
connection with the wireless access point
In the “LAN Bridge” mode: signal strength
of the connection with the first registered
wireless LAN device
Power flashing
• FRITZ!WLAN Repeater starting
• Updating the firmware of the
FRITZ!WLAN Repeater
on FRITZ!WLAN Repeater is ready for operation
WLAN flashing
• FRITZ!WLAN Repeater adopts wireless
LAN settings
• Switching wireless radio network on or
off
• Performing WPS
flashing rapid-
ly
WPS aborted. More than two wireless de-
vices are performing WPS at the same
time. Restart WPS.
on Wireless LAN is enabled
TV flashing Performing channel search
on TV signal found
off No TV signal
All flashing Loading factory settings
To Next Page
Loading...
