Cleaning the
coolant pre-filter
inside the unit
(CU 1200i
Pro /MC only)
WARNING!
Danger from welding current and accidental ignition of an arc.
This can result in serious injury and damage to property.
▶
Disconnect the ground earth connection between the welding system and the work-
piece.
▶
Remove the wire electrode from the welding torch being used.
▶
Depending on the system, remove the wirespool or the basket-type spool from the
power source or the wirefeeder.
1
2
WARNING!
Danger from coolant leakage.
This can result in serious personal injury
and damage to property.
▶
Immediately remove any coolant that
enters the device and / or spills onto
its exterior.
59
EN
To Next Page
Loading...
