Putting the power source into service
Safety
WARNING!
Danger due to work on the device.
If the power source is connected to the mains electricity supply during installation, there
is a high risk of very serious injury and damage.
▶
Before putting the machine into service for the first time, read the section hea-
ded “Safety rules”.
▶
Only carry out these preparations if the mains switch is in the “0” position
▶
Only carry out these preparations if the mains cable is unplugged from the mains.
Connecting up
the power source
Connecting the mains cable to the mains plug
1
Connect the mains cable to the mains
plug
2
Connect up the control leads as
shown in the operating instructions for
the interface
3
Connect the current cables to the cur-
rent sockets
43
EN
To Next Page
Loading...