Fronius DPS 2500 - Advanced Troubleshooting and Error Codes; Extended Service Codes and Error Handling

Code n°: 13
Error in temperature sensor n° 3
Contact After-Sales Service
Cause:
Remedy:
Code n°: 14
Error in temperature sensor n° 4
Contact After-Sales Service
Cause:
Remedy:
Code Nr.: 15
Error in temperature sensor n° 5
Contact After-Sales Service
Cause:
Remedy:
Code n°: 16
Error in temperature sensor n° 6
Contact After-Sales Service
Cause:
Remedy:
Code n°: 17 to 21
DSP error
Contact After-Sales Service
Cause:
Remedy:
Code n°: 22 to 27
HOST error
Contact After-Sales Service
Cause:
Remedy:
Code n°: 29
DSP error
Contact After-Sales Service
Cause:
Remedy:
Code n°: 31 to 32
Host error
Contact After-Sales Service
Cause:
Remedy:
Code n°: 33
Overtemperature in control circuit of power source
Allow the power source to cool down
Cause:
Remedy:
Code n°: 34
Error in temperature sensor n° 7
Contact After-Sales Service
Cause:
Remedy:
Code n°: 35 to 36
DSP error
Contact After-Sales Service
Cause:
Remedy:
Code n°: 35 to 36
DSP error
Contact After-Sales Service
Cause:
Remedy:
Code n°: 38
SPS or field bus master is not ready
Initialise “Robot ready” signal, initialise “Source error reset” signal
Cause:
Remedy:
Code n°: 49
Phase failure
Check the mains fuse protection, supply-lead and plug
Cause:
Remedy:
45
EN