Fronius FK 2500 - General; Device Concept; Application Areas; Scope of Supply

General
Device concept The cooling unit and the power source
form a unit. As with the standalone power
source, the power source/cooling unit
combination can be mounted on the trol-
ley.
The cooling units described in these
instructions can be operated with all power
sources in the:
- TransTig 2500 / 3000 series
- MagicWave 2500 / 3000 series
Application areas The FK 2500 cooling unit can be used for:
- manual and automated applications with the MagicWave 2500/3000 and TransTig
2500/3000 power sources
- TIG cold-wire welding
- water-cooled TIG manual welding torches
- water-cooled TIG machine welding torches
- water-cooled TIG robot welding torches
Scope of supply - Cooling unit
- 5 l coolant in a canister
- Four "Extrude-Tite" Allen screws (for securing the power source on the cooling unit)
- Four M5 hexagonal nuts (for securing the power source on the cooling unit)
- One 2 A fuse (spare)
- Operating instructions
Device variants
and their equip-
ment
FK 2500 equipment:
- Centrifugal pump for single-shift operation
- Thermostat
FK 2500 FC equipment:
- Centrifugal pump for single-shift operation
- Thermostat
- Flow sensor
FK 2500 MV equipment:
- Centrifugal pump for single-shift operation
- Thermostat
- Auto-transformer (for multivoltage operation)
16