Fitting the cooling unit to the trolley
General The welding system can be fitted to a trolley to make the entire system more mobile.
NOTE!
If the welding system is not equipped with an auto-transformer, the cooling unit
must be installed right at the bottom.
Fitting the cool-
ing unit to the
trolley
1
If there are no fixing brackets fitted to
the trolley:
firmly screw each fixing bracket to the
trolley base using three "Extrude-Tite"
screws - use the screws supplied with
the trolley
2
Place the cooling unit on the base of
the trolley
3
Firmly attach the cooling unit to the
trolley base fixing brackets using two
"Extrude-Tite" screws at the front and
two "Extrude-Tite" screws at the rear -
use the screws supplied with the trol-
ley
23
EN
To Next Page
Loading...