Fronius TransPuls Synergic 3200 - Page 136

Setting range 0.1 - 9.9
Factory setting 1.0
I-E
I (current) - End - Final current
Unit % (of starting current)
Setting range 0 - 200
Factory setting 50
t-S
time - Starting current - Starting current duration
Unit s
Setting range OFF or 0.1 - 9.9
Factory setting OFF
t-E
time - End current - Final current duration
Unit s
Setting range OFF or 0.1 - 9.9
Factory setting OFF
SPt
Spot welding time
Unit s
Setting range 0.1 - 5.0
Factory setting 1.0
F
Frequency - for SynchroPulse option
Unit Hz
Setting range OFF or 0.5 - 5
Factory setting OFF
dFd
delta Feeder - Welding power offset for the SynchroPulse option (defined by the wire
feed speed)
Unit m/min ipm
Setting range 0.0 - 2.0 0.0 - 78.74
Factory setting 2,0 78.74
AL.2
Arc length correction 2 (for the upper operating point of the pulsed welding power with
the SynchroPulse option)
Unit % (of welding voltage)
Setting range ± 30
Factory setting 0
NOTE!
The arc length correction for the lower operating point is made using parameter
AL.1.
136
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044