20
Optional installa-
tion and conver-
sion kits
Expansions and
versions
900 A VR 1500 installation kit (VR 1500 - 11, VR 1500 - 12 and VR 1500 - 30 only,
each with Fronius central connector F++)
for subsequent retrofitting so that the VR 1500 - 11, VR 1500 - 12 and VR 1500 - 30 are
suitable for a welding current of 900 A (incl. 2nd current socket)
VR 1500 basic torch blow out installation kit (max. 7 bar)
for subsequent installation of the optional basic torch blow out unit (= cleaning the welding
torch using compressed air, max. 7 bar)
High end torch blow out installation kit (15 bar)
for subsequent installation of the optional high end torch blow out unit (= cleaning the
welding torch using compressed air, max. 15 bar)
PMR 4000 PullMig, PM 43 installation kit
for subsequent installation of a push-pull unit
Gas nozzle touch sensor installation kit
for subsequent installation of the optional gas nozzle touch sensor (workpiece contact de-
tection by means of the gas nozzle)
VR 1500 gas pressure sensor installation kit
for subsequent installation of a gas pressure sensor
Digital gas control
for subsequent installation of the digital gas control
Gas economiser valve installation kit
for subsequent installation of a gas economiser valve
Fixable tensioning lever installation kit for plastic motor plate
for subsequent installation of a fixable tensioning lever so that contact pressure cannot
be accidentally adjusted
Wire-end connector installation kit
for subsequent installation of the optional wire-end connector (power source switches off
at the end of the wire)
Unreeling wirefeeder installation kit, 17-pin amphenol plug
for subsequent installation of a 17-pin amphenol plug (required to use the robot wirefeed-
er in conjunction with an unreeling wirefeeder)
Increased motor supply installation kit for VR 1500 - 12 (2 x 8 A) control unit
for subsequent installation of an increased motor supply if the VR 1500 - 12 is being op-
erated with an unreeling wirefeeder
CMT VR 1550 installation kit
for retrofitting the VR 1550 for CMT mode
VR 1500 MO/K holder
for fitting the robot wirefeeder to the robot arm
Robot wirespool holder
for fitting the wirespool holder to the robot
Cover for robot wirespool holder
VR 1500 - 22, VR 1500 - 11, VR 1500 - 12 and VR 1500 - 30 control unit
separate control unit in the event that the motor plate and control unit are used separately
To Next Page
Loading...
