29
EN
Connecting wire-feed unit to power source
General The wirefeeder is connected to the power source using the interconnecting hosepack.
Connecting the
wirefeeder to the
power source
1 2
WARNING! An electric shock can be fatal. If the machine is plugged in during in-
stallation, there is a high risk of very serious injury and damage. Only carry out
work on the device when
- the power source mains switch is in the "O" position
- the device is unplugged from the mains.
NOTE! When connecting the interconnecting hosepack, check that
- all connections are connected properly
- all cables, leads and hosepacks are undamaged and correctly insulated.
1
2
IMPORTANT! To prevent signs of wear and tear, the interconnecting hosepack cables/
pipes should be "looped inside". A strain-relief device is not provided in the case of 1.2 m
(3 ft. 11.24 in.) interconnecting hosepacks.
To Next Page
Loading...
