5. Remote Control Set Up &Notes
Battery Installation
1. Release the side latch and pull out the battery holder.
2. Install only a 3 volts CR2025 battery cell and place battery polarity + respectively to
the + sign of the holder.
3. Replace the battery holder.
Corrosion, oxidation, battery-leakage and any other gradually acidic defect of this nature will
invalidate the guarantee.
Notes:
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the battery as indicated in the
battery compartment. A reversed battery may cause damage to the device.
3. Don't drop, step or hit the remote control, these may cause inner damage or
malfunctions.
4. If not using for a long period of time, remove the battery to avoid possible damage due
to battery leakage.
Remote control effective range:
Aim the remote control at the unit IR receiver. The distance to the unit should be less than
5 meters and within ±30°(no obstacle’s).
The remote control may be less effective if:
1. Unit is placed under intense ambient lighting.
2. There are obstacles between the remote control
and IR receiver.
3. Other remote controls are operated at the same
time.
4. Low battery.
8
To Next Page
Loading...