ROTISSERIE LIGHTING INSTRUCTIONS
TO LIGHT THE ROTISSERIE BURNER:
1. Push and hold the Rotisserie Burner control knob for about 5 seconds without rotating.
This will allow time for the gas to flow into the Rotisserie burner.
2. Turn the knob to the "HI" position and the igniter will click to light the burner.
If the burner does not light in 4 seconds turn the control knob to "OFF". Wait 5
minutes and try again.
If the Rotisserie Burner does not light after several attempts, then refer to the "Match
Lighting Instructions" on this page.
TO MATCH LIGHT THE ROTISSERIE:
1. Locate Match Extender Lighting Rod found inside left grill door.
NOTE: If you have just attempted to light the Rotisserie burner with the igniter,
allow 5 minutes for any accumulated gas to dissipate.
2. Simply place a match between the coils on the end of the extension rod.
Keep your face and hands as far away from the grill as possible.
3. Light the match and place it next to the right-hand side of the Rotisserie Burner.
4. Press and turn the control knob left to the "HI" setting. Continue to press the knob until
the burner ignites. Burner should light immediately.
19
If the burner does not light in 4 seconds turn the control knob to "OFF".
Wait 5 minutes and try again.
If the burner does not light after several attempts, turn the control knob
to "OFF", and check the "TROUBLESHOOTING" section of this manual.
CAUTION: PLEASE TAKE OFF THE WARMING RACK WHEN USING THE ROTIS
BURNER. THE HIGH HEAT COMING FROM THE ROTIS BURNER MAY CAUSE
THE WARMING RACK TO BEND.
To Next Page
Loading...