TROUBLESHOOTING
23
PROBLEM SOLUTION
When I light the grill it does not
flame immediately.
• Make sure you have the gas turned ON.
• Make sure it has a spark while you are trying
to ignite the burner.
• Push the knob in for approximately 2-3 seconds
before turning to ignite the grill.
• Make sure your burner is clean.
Rotisserie burner will not light when the
control knob igniter is turned.
• Check to see if debris is blocking
the electrodes.
• Check to see if there is a spark.If no spark is
seen THEN:
- Check the battery located inside the Battery
Box housing behind the button. Press and
turn counter-clockwise.
- Check for loose wire connection.
- Gently bend the electrode wire closer to the
burner until a spark is seen to jump from the
igniter to the burner when turning the Control
Knob igniter.
- Does the infrared back burner light when
attempting to match light? If not, check to
see if the gas is turned "ON".
Regulator makes a loud noise (not a low
level hum).
• Vent hose on the regulator may be plugged or
regulator may be faulty
.
• If Liquid Propane: Disconnect regulator and
re-install.
• Ensure the vent hole on the regulator is not
obstructed. Clear the hole, close the gas control
valves. Wait five minutes and re-start.
• Check your flames for proper performance if
the flames are not correct replace regulator.
Rotisserie motor will not turn.
• Check the voltage at the outlet.
• If an extension cord is required, ensure it is a
16 gauge grounded cord.
• Ensure the ON/OFF switch is ON.
• Ensure the load does not exceed the 40 lb.
operational capacity
.
• Ensure the spit is fully inserted into the motor.
• Ensure there is no encumbrance or drag.
continued
To Next Page
Loading...