Dealer Instructions 8
Dealer Checklist
(Dealer’s Responsibility)
It is the dealer's responsibility to complete all pre-
assembly of the DH34 before delivery to the cus-
tomer. Pre-assembly instructions follow on page 9,
10.
Inspect the equipment thoroughly after pre-assembly
to be certain it is set up properly before delivering it to
the customer. The following check list is a reminder of
points to inspect.
Check off each item if it is found satisfactory or after
proper adjustment is made.
____ Check that all safety decals are installed and in
good condition. Replace if damaged.
____ Check all bolts to be sure they are tight.
____ Check that all cotter pins and safety pins are
properly installed.
____The disc gangs have been pre assembled at the
factory. It is important for the dealer to visually
check and make sure all parts are in tact prior to
delivery to customer.
____ Show customer the safe, proper procedures to
be used when mounting, dismounting, and storing
equipment.
____ For mounted units, add wheel weights, ballast in
front tires, and/or front tractor weight to enhance front
end stability. A minimum 20% of tractor and equipment
gross weight must be on front tractor wheels. When
adding weight to attain 20% of tractor and equipment
weight on front tractor wheels, you must not exceed
the ROPS weight certification. Weigh the tractor and
equipment. Do not estimate!
____ Show customer how to make adjustments.
____ Present Owner’s/Operator’s Manual and request
that customer and all operators read it before operating
equipment. Point out the manual safety rules, explain
their meanings and emphasize the increased safety
hazards that exist when safety rules are not followed.
____ Point out the safety decals. Explain their mean-
ing and the need to keep them in place and in good
condition. Emphasize the increased safety hazards
when instructions are not followed.
____ Explain to customer the potential crushing haz-
ards of going underneath raised equipment. Instruct
customer that service work does not require going
underneath unit and never to do so.
____ Complete the Warranty Registration located on
the Frontier website.
Dealer Instructions
To Next Page
Loading...
