Follow the instructions in reverse, if while working under normal conditions the clutch
does not slip at all.
3.12 - Pre-Operational Check
Check each of the following, carefully, prior to engaging machine:
1. The rotor support has been greased and the drive chain is lubricated.
2. The oil in gearbox is between
1
/
2
and
2
/
3
full.
3. The driveline cross & bearings have been greased.
4. No wrappings or foreign objects are on the machine or driveline.
5. The blades are properly installed and the blade bolts and nuts properly torqued
4
.
6. All hardware is tight
5
.
7. The tractor to ensure correct direction of rotation of PTO and rpm speed.
8. All safety shields and guards are in their place and tightly attached.
9. No people or animals are in the work area.
10.Local utility companies have been contacted to make certain there are no bundled
gas lines, electrical cables, etc., in the work area.
11.When working, make sure the aerator-overseeder has its full weight riding on the
roller. The front of the machine should be held upward at a slight angle by the tractor
arms.
DANGER: Always stay clear of rotating driveline and blades when the PTO is
engaged.
WARNING: Disengage the PTO, apply the parking brake, shut off the engine and
remove the key before attaching or removing the driveline, or performing any
maintenance or adjustments on the machine.
3.13 - Attaching to the Tractor
Unit may be used on tractors ranging from 25 to 45 HP equipped with a standard rear
PTO and category 1 three point hitch.
6
DANGER: Never attempt to attach the aerator-overseeder to the tractor or make
any adjustments to it without first turning the tractor off.
OPERATION 22 FRONTIER
A
ERATOR-OVERSEEDER OPERATOR’S MANUAL
6
See Table 5, page 29.
5
See Table 4, page 29.
4
See Table 4, page 29.
To Next Page
Loading...