Layout of Delta wing / Flying wing
Layout of V-tail
Delta wing & Flying wing & V-tail
1. When Delta wing/Flying wing is selected, the signal produced by the transmitter should be without active mixes
on the channels related to AIL and ELE. Archer Plus SR8 will mix the AIL (CH1) and ELE (CH2) input signal
with a fixed mix percentage automatically.
2. When V-tail type is selected, the signal produced by the transmitter should be without active mixes on the
channels related to ELE and RUD. Archer Plus SR8 will mix the ELE (CH2) and RUD (CH4) input signal with
a fixed mix percentage automatically.
Stabilization:
When the model is activated, Archer Plus SR8 will compensate with external forces (wind) as soon
as receiving commands from the transmitter. This function is used to enhance the stability of the model on three
axis (Pitch, Roll, YAW). CH13 could be used to adjust gyro gain by assigning a knob or a slider, changing the
sensitivity of the counteracting signal produced by the internal three-axis gyroscope.
Automatic level:
When the mode is activated, Archer Plus SR8 will make the model return to level orientation
with internal three-axis accelerometer and three-axis gyroscope on AIL and ELE channels after the sticks being
released to neutral. RUD channel works in stabilization mode only.
Hover:
When the mode is activated, Archer Plus SR8 will make the nose of the model straight up with internal
three-axis accelerometer and three-axis gyroscope on RUD and ELE channels (ELE and RUD inputs are not
required). Under this mode, AIL is used to control the rotation of the model and THR adjust the altitude. AIL
channel works in stabilization mode only.
Knife-egde mode:
When the mode is activated, Archer Plus SR8 will roll the plane on a certain side (wing points
up) with internal three-axis accelerometer and three-axis gyroscope on RUD and AIL channels.Thus, AIL inputs
are not required. While the mode steering is done with ELE, altitude will be maintained with THR/RUD. ELE
channel operates in stabilization mode only.
Off:
When the mode is activated, Archer Plus SR8 will transmit the received commands produced by the transmit-
ter to the model without compensating.
Flight mode Stabilization Auto Level Off
CH14
CH14>M+H
(CH14 SW Down)
CH14<M-H
(CH14 SW Up)
CH14 SW-Mid
The available flight modes can be assigned to CH14 with a three-position switch.
Note:
M:
represents a neutral signal period (1500μs)
H:
represents the time of required signal change to activate the mode (50μs). When the factory settings are
selected, the switch position shown above represents the required modes.
Version
1.0
Instruction Manual for FrSky ARCHER PLUS SR8 Receiver
FrSky Electronic Co., Ltd. www.frsky-rc.com Contact us : frsky@frsky-rc.com
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: sales4tech@gmail.com
CH14 SW-Mid
Off
CH14 (3 pos SW)
CH15 (3 pos SW)
Stabilization
CH14>M+H
(CH14 SW Down)
M-H<CH15<M+H
(CH15 SW Mid)
Automatic level
CH14>M+H
(CH14 SW Down)
CH15>M+H
(CH15 SW Down)
Hover
CH14>M+H
(CH14 SW Down)
CH15<M-H
(CH15 SW Up)
Knife-Edge
CH14<M-H
(CH14 SW Up)
M-H<CH15<M+H
(CH15 SW Mid)
Flight mode
To Next Page
Loading...
