FrSky RX6R - User Manual

X
X
X
Smart Port (S. Port) is a signal wire full duplex digital transmission interface developed by FrSky
Electronic Co., Ltd. All products enabled with Smart Port (including XJT module, XSR,X6R and X8R receiver,
new hub-less sensors, new Smart Dashboard, etc), serial port user data and other user input/output devices
can be connected without limitations for numbers or sequences at a high transmission speed.
Inverted S.Port signal

Summary

Introduction to FrSky RX6 R Receiver

FrSky RX6 R Receiver Overview

FrSky RX6 R Receiver Diagram and Components

Diagram showing CH1-CH6, SBUS IN/OUT, RF-SKY RX6R module, and Smart Port with numbered indicators.

Smart Port (S. Port) Description

Explanation of FrSky's Smart Port, a full duplex digital transmission interface for data.

FrSky RX6 R Key Features

Whats New in FrSky RX6 R

FrSky RX6 R Technical Specifications

FrSky RX6 R LED Working State Indicators

Configuring CH16 Output on FrSky RX6 R

How to configure CH16 to output RSSI or CH16 by holding the bind button.

FrSky RX6 R Binding Procedure

Binding FrSky RX6 R with Taranis Transmitter

Steps for binding RX6R using Taranis transmitters via MENU-MODEL SETUP.

Binding FrSky RX6 R with Horus Transmitter

Steps for binding RX6R using Horus transmitters via RF SYSTEM.

Binding FrSky RX6 R with XJT Module

Steps for binding RX6R using an XJT transmitter module.

Switching Between FS and HS Modes on FrSky RX6 R

FS Mode Default Setting

RX6R defaults to FS mode. HS mode requires connecting CH1 and CH2 signal pins.

Identifying HS and FS Modes on RX6 R

Blue LED ON indicates HS mode; Blue LED OFF indicates FS mode.

Selecting Output Channels 1-6 CH and 9-14 CH

FrSky RX6 R Range Check Procedure

FrSky RX6 R Failsafe Configuration

FrSky RX6R Specifications

General

Type	6-channel receiver
Frequency	2.4GHz
Telemetry	Yes
Number of Channels	6
Firmware Upgradeable	Yes
Compatibility	FrSky ACCST and ACCESS
Input Voltage	4.0V - 10V
RSSI Output	Yes