Need help?Do you have a question about the FrSky Taranis and is the answer not in the manual?
General| Model | Taranis |
|---|---|
| Frequency | 2.4GHz |
| Telemetry | Yes |
| Operating System | OpenTX |
| Backlight LCD Screen | Yes |
| Firmware | Upgradable |
| SD Card Slot | Yes |
| Audio Output | Yes |
| Haptic Feedback | Yes |
| USB Port | Yes |
| Trainer Port | Yes |
| Module Bay | Yes |
| Channels | 16 |
| Battery | 6-15V (2S-3S LiPo) |
| Display | LCD |
| Operating Voltage Range | 6-15V (2S-3S LiPo) |
| Operating Temperature | -10°C to +60°C |
| Model Memories | 60 |
| Compatibility | FrSky |
| RF Power Output | 100mW |
Covers PC connection, file copying, OpenTx Companion usage, and stick calibration.
Outlines objectives for symmetrical setup, max movement, and linear response, stressing importance.
Details how to set the rotation direction for each servo output.
Explains setting servo end points and defaults for calibration.
Steps to calibrate the left flap servo, setting end points and linearity.
Steps to calibrate the right flap servo, matching the left flap curve.
How to set the neutral position for flaps using Global Variable GV5.
Calibrating V-tail elevator servos for correct travel and matching.
Calibrating elevator servos for X-tail configurations.
Calibrating the rudder servo for X-tail configurations.
Final calibration of aileron servos for correct centering and matching.
Instructions on how to back up the transmitter's EEPROM to the SD card.
To Next Page