1-9
1.7 Main Menu: Product Setup (Single Setpoint Cooking)
Programming food items is shown below. Ensure the controller is OFF and follow the steps. The right column has the
action necessary to continue. Exit from a programming step at any time by pressing the Exit/Scan key until the display
returns OFF. Items shown in gray will not appear if the option that activates them is not enabled.
Left Display Right Display Action
OFF OFF
Press until the controller scrolls INFO MODE, changing to MAIN
and then PRODUCT SETUP.
Product Setup
Blank
Press .
Product Setup Enter Code
Enter 1650.
Select Product
Blank
Press desired product button.
Long Name Product name or
button number
Enter product name with letter keys. Advance cursor with . Press
to advance to next product set up feature.
Short Name Abbreviated
Product name or
button number
Enter four character product name which alternates with the timer
during a cook. Press .
COOKING MODE SINGLE SETPOINT
Press . If multiple setpoint or segmented cooking is desired press
MULTIPLE SETPOINT and go to 1.8 and follow the instructions.
(Default is SINGLE SETPOINT.) Doesn’t appear if Cooks is disabled.
1 Time 0:00 or
previously
entered time
Enter total cook time with numbered keys. Press .
1 TEMPR TEMPR
Enter cooking temperature. Press .
1 Sensitivity
Number
Enter the level of sensitivity, 0-9, for the product. Press . Refer to the
sensitivity chart on page 1-17.
1 alarm time (Shake
Time)
0:00 or
previously
entered time
Enter time in cook cycle for audible alarm for shaking. Press . If set
to 0:00 skip to FILTER PROMPT.
1 ALARM NAME SHAKE
Press to scroll through the alarm names (ex. Shake, Stir). Press .
1 ALARM MODE (Shake
Alarm Mode)
AUTO
Press . Default is auto. If manual is desired press to scroll to
Manual shake alarm mode. Press . Alarm (Shake) Mode when set to
auto, cancels the alarm automatically after a few seconds. Manual
requires user action.
1 ALARM TONE (Shake
Alarm tone)
Short
Press to scroll choice of shake alarm tones. Press . Default is
SHORT.
2 alarm time 0:00
Press . Leave at 0:00 if a second alarm is not needed. Enter time if
needed and follow steps above for entering other parameters. Repeat for
third alarm time. (If 0:00 is entered for second alarm, the steps for the
third alarm do not appear.)
Filter PROMPT
0 or previously
entered number.
Enter number of cook cycles before a filter prompt and press .
Doesn’t appear if Filters is disabled in Tech Mode.
Instant On
5 or previously
set number
This is the time, in seconds, the fryer heats at 100%, after the product
button is pressed before the controller adjusts the temperature. Enter
value and press . (Default is 5. 0=OFF). NOTE: Instant on time
may need to be adjusted for light cooking loads. Doesn’t appear if
Cooks is disabled.
HOLD TIME
0 or previously
entered time.
Enter time in minutes to hold product before discarding. Press .
Exit Exit
Press the button to save changes.
Select Product
Blank
For additional programming refer back to Product Setup above. To exit
press the EXIT SCAN button twice to OFF.
To access menu strip, remove screws attaching bezel. Lower bezel and remove strip from back of controller. Once the
menu strip is updated, reverse the steps to reassemble. To unassign a product from a button set the cook time to 0:00 and
press EXIT/SCAN.
To Next Page
Loading...
Need help?
General
