1-17
and follow the prompt.
CLOSE OIL RETURN VALVE CONFIRM
Close the oil return valve and press or .
Switch to fryer mode Confirm
Using the mode switch, switch to FRYER MODE
and press or .
off off
1.10.6 Boil Out* (NOTE: To enter boil out mode, the controller must be OFF)
*Not available with Filters option disabled.
DANGER
Never leave the fryer unattended during the boil-out process. If the boil-out solution boils over, turn
the fryer off immediately and let the solution cool for a few minutes before resuming the process.
WARNING
Do not drain boil-out solution into a shortening disposal unit (SDU), a built-in filtration unit, or a
portable filter unit. These units are not intended for this purpose, and will be damaged by the solution.
Left Display Right Display Action
Follow steps to Entering Filter Menu Mode on page 1-12. The controller must be off.
BOIL OUT
Blank
Press .
Boil Out Now? Yes No
Press to continue.
IS VAT PREPARED? Confirm
Ensure vat is empty and drain closed; press or .
REMOVE Filter Pan Confirm
Remove the filter pan and press or .
IS SOLUTION IN THE VAT? CONFIRM
Ensure solution is in the vat and press or .
START BOIL OUT Confirm
Press or .Turns on and heats to 195ºF (91 ºC). The
boil-out timer starts.
BOIL OUT 30:00
The countdown timer begins.
Boil Out Done CONFIRM
Press or to confirm and cancel the alarm.
IS SOLUTION REMOVED? CONFIRM
Once solution is removed press or .
OFF OFF
DANGER
Remove all drops of water from the frypot before filling with oil. Failure to do so will cause spattering
of hot liquid when the oil is heated to cooking temperature.
1.11 Polishing
The 3000 Version 3 displays a series of prompts when a polish filter cycle is under way. To initiate a polish, press and hold
the arrows simultaneously. The steps are detailed below. A “waiting to polish” message may display until the signal
is received that the vat is ready for polish cycle to begin.
Left Display Right Display Explanation/Action
Polish Now? Yes NO
Respond to prompt with button push. Press under YES or
under NO. Yes starts a polish, detailed below. No delays
filter for 30 minutes and cooking continues. Answering NO
after two prompts cancels polish.
Filter PAN READY? Confirm
Press or when pan is replaced after inspection.
OPEN DRAIN VALVE
Blank Open the drain valve.
Draining
:40 sec. countdown timer None required.
Turn Filter On Confirm
Turn filter on and press or .
POLISHING 15-MINUTE COUNTDOWN TIMER
None required. The oil flows from the filter pan to the frypot
and back to the filter pan for 15 minutes.
To Next Page
Loading...
Need help?
General
