1-1
CHAPTER 1: 3000 VERSION 3 CONTROLLER INSTRUCTIONS
1.1 Using the 3000 Version 3
ON/OFF
Press ON/OFF button. Fryer begins melt cycle to slowly heat solid shortening to programmed temperature before
switching to full temperature and heating to setpoint or idle temperature and displays: READY.
Exit melt cycle, when using liquid oil, by pressing and releasing the Exit Cool button or any programmed product
button. Displays show Exit Melt? on left and YES NO on the right. Press to exit.
Cooking
COOL displayed: Press product button or Exit Cool; fryer heats to setpoint and displays READY.
READY displayed: Press product button and drop product.
-- displayed: The vat temperature is out of the Ready zone.
DONE displayed: Press blinking product button to cancel alarm and end a cook.
HOLD displayed: Press blinking product button to cancel hold alarm.
Cancel a Cook: Press and hold blinking product button to cancel cook cycle.
Change setpoint: Press a product button with the desired temperature. Press the product button again and a cook
starts. NOTE: When a product button with a setpoint different than a currently cooking product is pressed, a low tone
is heard and the new cook won’t start until the cook is finished.
Controller Button Navigation
Product: Press to start a cook cycle. Active when adjacent LED is lit. LED flashes during a cook cycle. Press and
hold to cancel a cook cycle. Press at end of cook cycle to cancel an alarm. Press and hold a product with different
setpoint to change setpoint temperature.
Exit/ Scan: Press once; all product buttons are lit. Select Product displayed. Press product button to view product
name. Press to advance through all product parameters. Press Exit Scan again to repeat. Press Exit Scan twice
to escape.
Left/Right Arrows: Navigate options in left display. Press both simultaneously to start a polish cycle.
Up/Down Arrows: Navigate options in right display. Press both simultaneously to change to a second language if
one is selected in setup.
Exit Cool: Exits cool mode, returns fryer to setpoint temperature.
Thermometer: Fryer ON: Press and release for setpoint in left display and vat temperature in right display.
Thermometer, Fryer OFF: Press to display temperature, time, date, system version, controller and circuit board
software versions.
Checkmark: Fryer OFF: Press and hold 3 seconds: Scroll filter usage; Press and hold 10 seconds: Product
setup.
Checkmark: Fryer ON: Enter Codes, Respond to left display prompts.
Filter: Press and release: Cooks remaining to filter cycle. Press and hold: Filter options: Filter, Clean and Filter,
Dispose, Fill Vat from Bulk (Bulk option only) and Boil Out (OFF only).
To Next Page
Loading...
Need help?
General
