FS S5300-12S - Connecting the Power; Configuring the Switch

7
EN
WARNING: Do not install the power cord while the power is on.
1. Plug the AC power cord into the power port on the back panel of the switch.
2. Connect the other end of the power cord to an AC power source.
Connecting the Power
Configuring the Switch
Step 1: Connect a computer to an Ethernet port of the switch using the network cable.
Step 2: Set the IP address of the computer to 192.168.1.x ("x" is any number from 2 to 254). Set the
subnet mask of the computer to 255.255.255.0.
Conguring the Switch Using the Web-Based Interface
POWER
Input: 100-240Vac
Freq: 50/60Hz