FS S5860-24XB-U - Factory Reset Procedures; Networking Requirements for Factory Reset; Factory Reset Network Topology; Configuration Steps for Factory Reset

S5860-24XB-U SWITCH RESET AND RECOVERY SYSTEM CONFIGURATION GUIDE
www.fs.com
4
2. Reset
2.1 Networking Requirements
(1) After restoring the factory settings, the original configuration will be cleared. If the configuration is more important, please backup the
configuration to the local computer first.
(2) After restoring factory settings, the default ip is 192.168.1.200, web interface user name and password admin/admin
(3) The console cable and RJ45 network cable of the switch need to be prepared.
2.2 Network Topology
2.3 Configuration Steps
2.3.1 Factory Reset via CLI Interface
Log in to the CLI interface of the switch, connect the console port of the switch with a console cable, open the hyper terminal CRT, and set
related parameters.
Enter the set user name and password, execute dir to view the file.
Switch>enable
Switch#dir