FScurtis iCommand-Touch - Basic Load Cycle Pressure Times; Times for Basic Load Cycle Priorities; Figure 19: Timer for Changing over Priorities for Basic Load Cycle; Figure 20: Page 1 of Channel Settings for Times for Basic Load Cycle Priorities

FSCurtis ICommand-Touch V1.15 01.08.2016
61
4.10.5 Basic load cycle pressure times
The basic load cycle pressure times are defined in this menu (raise / lower). This only
applies to the basic load cycle master. Programming is as described for the "Compressor
pressure times" in Section 4.4.3
4.10.6 Times for basic load cycle priorities
The switching times for changing the priorities of the basic load cycle are defined in this
menu. This only applies to the basic load cycle master. Programming is as for other
timers, for example "Compressor switching times" in Section .
Figure 19: Timer for changing over priorities for basic load cycle.
Figure 20: Page 1 of channel settings for times for basic load cycle priorities.
The priorities for each of the switching times can be seen on page 2 of the channel (see
Figure 21). The same priority levels as those defined under are available.