What to do if my FSI Monitor image has a heavy green or magenta cast over SDI?
If your FSI Monitor image displays a heavy green or magenta cast over SDI, set the SDI Format to match your signal type. This setting is located at the bottom of the Video Menu.
How to fix a heavy green or magenta cast over DVI on my FSI BM?
To correct a heavy green or magenta cast over DVI on your FSI Monitor, set the DVI Pixel Format selection on the System Menu to match your signal format (RGB or YCbCr).
General| Panel Type | IPS |
|---|---|
| VESA Mount | 100x100mm |
| Display Size | 27 inches |
| Screen Size | 27 inches |
| Inputs | HDMI, DisplayPort |
| Response Time | 5ms |
| Contrast Ratio | 1000:1 |
| Viewing Angle | 178°/178° |
| Ports | HDMI, DisplayPort, SDI (optional) |
| Power Consumption | 30W (typical) |
To Next Page
