SAFETY AND HANDLING
56
SPILL & DISPOSAL PROCEDURES – POLYOL (B)
SPILLS/LEAKS: Refer to SDS.
1. Evacuate and ventilate spill area. Notify appropriate personnel.
2. Wear appropriate protective equipment during clean up. See SDS.
3. Dike spill to prevent entry into water or sewage system.
4. May present a slipping hazard.
MAJOR SPILL:
1. Call Foam Supplies, Inc. at 1.314.344.3330
2. For spills in transit, call CHEMTREC:
Inside USA 1.800.424.9300
Outside USA 1.703.527.3887
3. Dike chemical and divert flow if possible. Large quantities should be pumped into closed containers for
disposal.
4. See Minor Spill for clean up procedure.
MINOR SPILL:
1. Absorb with dry sawdust, floor-dry, sand, clay soil, or other suitable absorbent material.
2. Remove and store in containers. Label as required.
DISPOSAL METHOD:
1. Follow all Federal, State and Local regulations.
2. Contact a licensed hazardous waste disposal contractor for proper disposal.
3. Obtain certification and receipts of proper disposal from contractor.
Read through all the steps before starting procedure. Please refer to the appropriate
MSDS for proper safe handling including the use of safety glasses, protective gloves,
and respirator protection where needed. For any reason if you do not understand, or
are uncertain of any or all procedures and instructions given to you by Foam Supplies,
Inc. and its representatives, please contact our Application Specialist first before
attempting procedures. We will be happy to assist.
IMPORTANT
PROTECTIVE EYEWEAR AND GLOVES REQUIRED!
www.foamsupplies.com | www.ecomatetechnology.com | 1.800.325.4875
To Next Page
Loading...
Need help?
General
