5
2.2 Specifications and accessories of the blower
If you purchased a standard product, refer to the standard specifications in the following table.
For a custom-made product with special specifications, refer to the specifications including the
external dimensions drawing.
Caution
Do not use this product under any conditions other than those
provided in the specifications. Failure to observe this may cause an
electric shock, fire, and/or product failure.
(1) Standard specifications and special specifications
KT-010S/010T/020S/020T/040S/040T/100T
Clean air
Air
0°C to 60°C
Installation location Indoor (ambient temperature: 0°C to 40°C)
Installation method Floor mount (only in the orientation where the shaft is
placed horizontally)
Type
Totally enclosed type (0.1/0.2kW),
Totally enclosed fan-cooled type (0.4/1.0kW)
50Hz, single phase 100V, 3 phases 200V (1.0kW output is
only achieved at 3 phases 200V.)
Motor
Phase, voltage
60Hz, single phase 100V, 3 phases 200V (1.0kW output is
only achieved in 3 phases 200V.)
Inside······· Modified alkyd resin coating (silver color)
Standard specifications
Coating
Outside ···· Polyurethane resin coating (silver color)
Outdoor type
Hot gas type (Gas at over 60°C and up to 250°C)
Structure
modifications
Special orientation of discharge flange
Special
specifications
Motor modifications Different voltage
KT-
*
075/
*
150/
*
220/
*
370
Clean air
Air
0°C to 150°C (Except for motors of enhanced safety or
explosion-proof type)
Installation location Indoor (ambient temperature: 0°C to 40°C)
Installation method Floor mount (only in the orientation where the shaft is
placed horizontally)
Type Totally enclosed fan-cooled
50Hz, 3 phases, 200V
Motor
Phase, voltage
60Hz, 3 phases, 200/220V
Inside······· Heat resisting coating (silver color) *2
Standard specifications
Coating
Outside ···· Heat resisting coating (silver color) *2
To Next Page
Loading...