EasyManua.ls Logo

Fugoo GO FSNA3 - Bluetooth Device Management; Disconnecting Bluetooth Devices; Reconnecting Bluetooth Devices; Clearing All Bluetooth Pairings

Fugoo GO FSNA3
13 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User Manual Fugoo GO Bluetooth Speaker Model FSNA3 page 6 1/27/2017
If you are using an iPhone or an iPad that has been previously paired to the
speaker, and all Bluetooth pairings have been cleared, it may be necessary
to 'Forget this Device', as follows:
1. Tap Settings.
2. Tap Bluetooth.
3. Tap the icon to the right of 'Fugoo GO Speaker'.
4. Tap 'Forget this Device'.
5. Tap 'Forget Device'.
As long as the speaker is in pairing mode, the iPhone should find the speaker
again, and pair with it.
Disconnecting from another Bluetooth device
To disconnect your Fugoo GO Bluetooth Speaker from a Bluetooth source device, you
can:
Hold the (Bluetooth) button on your speaker for 3 seconds
Move your speaker and the Bluetooth source device apart until they disconnect.
Turn off your speaker.
Turn off the Bluetooth source device.
Turn off Bluetooth on your Bluetooth source device.
Plug an audio cable into the speakers audio input jack.
Disconnecting temporarily interrupts the Bluetooth wireless link between the speaker
and the currently paired source device, which permits the speaker to re-connect with
another source device to which it has been previously paired. The disconnected
device will still be paired with the speaker, allowing them to automatically reconnect
at another time.
Reconnecting
To reconnect to a Bluetooth source device to which you have previously paired, just
turn on the speaker and the source device, and place them within 33 feet (10
meters) of each other. It’s also necessary that no cable be plugged into the audio
input jack. Typically, speaker and the source device will reconnect automatically.
If voice prompts are enabled, the speaker says "Connected".
Clearing all Bluetooth source device pairings
To clear all of the Bluetooth pairings with source devices, turn the speaker on, and
then hold the (Bluetooth) button for eight seconds, until the speaker says "All
Bluetooth pairings cleared. Pairing mode. Please use the Bluetooth settings of your
device to connect.”

Related product manuals