Fuji Electric FRENIC-Lift FRN0011LM2A-7 User Manual

Instruction Manual
LM2A series
■Three-phase 400 V ： FRN0006LM2A-4□ to FRN0091LM2A-4□
■Single-phase 200 V ： FRN0011LM2A-7□/FRN0018LM2A-7□
Thank you for purchasing our FRENIC-Lift LM2A series of inverters.
• This product is designed to drive three-phase induction motors and three-phase permanent magnet
synchronous motors. Read through this manual to become familiar with the handling procedure and
correct use.
• Improper handling might result in incorrect operation, short life cycle, or failure of this product as well as
the motor.
• Deliver this manual to the end user of this product. Keep this manual in a safe place until this product is
discarded.
• For instructions on how to use an optional device, refer to the instruction and installation manuals for that
optional device.


Fuji Electric Co., Ltd. INR-SI47-1894d-E

Fuji Electric FRENIC-Lift FRN0011LM2A-7 Specifications

General

Model	FRN0011LM2A-7
Type	Inverter
Voltage Class	200V Class
Rated Output Power	1.1 kW
Cooling Method	Forced air cooling
Enclosure Rating	IP20
Input Voltage	Three-phase 200 to 240V
Output Voltage	Three-phase 200 to 240V
Control Method	Vector control, V/f control
Protection Features	Overcurrent, Overvoltage, Overheat
Operating Temperature	-10°C to +40°C
Storage Temperature	-20°C to +65°C
Humidity	90% RH or less (non-condensing)
Altitude	1000m or less

Summary

Preface and Safety

Safety Precautions

General safety warnings and classifications for safe operation.

Application Precautions

Installation and Wiring Precautions

Installation Precautions

Safety guidelines for installing the inverter securely and safely.

Wiring Precautions

Critical safety warnings for electrical wiring of the inverter.

Operation Precautions

Operation Precautions

Safety warnings and guidelines for operating the inverter.

Maintenance and Inspection

Daily and Periodic Inspections

Standards Compliance

EU Low Voltage Directive Compliance

Canadian and US Standards Compliance

EMC Standards Compliance

Functional Safety Standard Compliance

Information on compliance with functional safety standards.

Chapter 4: Running the Motor for a Test

Test Run Procedures

Chapter 5: Troubleshooting

Alarm Codes

List and description of alarm codes for troubleshooting.

Chapter 7: Specifications

Standard Model Specifications

Technical specifications for standard inverter models.